Skip to main content

Questions tagged [tubing]

The tag has no usage guidance.

Filter by
Sorted by
Tagged with
1 vote
0 answers
18 views

Aluminum tube deflection

We're designing a new start bar for the Harris Hill Ski Jump in Brattleboro, VT. It's the bar the jumper slides out to sit on as he/she awaits the okay to go. Will the tube specs below be sufficient ...
0 votes
0 answers
17 views

Split tubing assembly

I am designing a tubing (TPE) assembly that splits a single inlet line into either four or eight outlet lines. The goal is to achieve an approximately equal flow rate of mildly viscous liquid at each ...
0 votes
0 answers
343 views

Aluminum Tubing Weight Bearing Capabilites

I was just inquiring about the weight bearing capability of round aluminum tubing for use as a bench,seat, or chair. Similar to the aluminum seats used in doctors' offices and in hospitals. I see that ...
1 vote
1 answer
28 views

Suitable pipe suggestion required

I've got a machine that sucks water. The inlet is half inch. I had been using braided pvc till now but it has started to breathe air which is causing problems with the machine. It also bends under ...
2 votes
1 answer
56 views

Component selection type for fluid-mechanical system

I am creating an enclosure and need to get a water supply through a plastic wall inside to the core device. I imagine this water line will be a flexible tube and will screw on or snap to an adapter on ...
0 votes
0 answers
117 views

How to rescrew a pull up bar

Is there a way to fix a pull up bar when the tip screwed right off and won't screw on again? The thread hole hits the screw (detail) and just clunks there, spinning round and round without latching.
0 votes
1 answer
41 views

Adhesive to connect metal with a coating to plastic that resists mineral oil

I have a peristaltic pump that was having some leaks because of connections between the tubing so I decided to replace it all with a single piece of tubing. Upon doing this though, I observed that the ...