Questions tagged [systems-engineering]

Systems Engineering is a multidisciplinary field that combines lifecycle planning and risk analysis with core features of other engineering disciplines. It includes understanding physical systems, organizational planning, computer modeling, and information management. It is also commonly used to describe a position in information technology which involves managing multiple technology stacks and overseeing computer networks.

10 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
8
votes
0answers
163 views

Sketching an engineering system in healthcare

I am about to do a project about engineering systems in a Systems Engineering course. I need to sketch an engineering system in which clinical decision support systems are being used to diagnose ...
6
votes
1answer
201 views

System Dynamics Modeling

I am trying to model this system but am having difficulties in setting up the equations of motion. This is a simplified model of a motorcycle suspension system, where P is the ground in the image ...
2
votes
0answers
111 views

How do I calculate the velocity of the piston?

I have a system with a motor connected to the trapezoidal lead screw. The lead screw is connected to the tube which is connected to the piston. The piston has to pump 1000cc oil against a pressure of ...
2
votes
0answers
31 views

How do I perform RM scheduling?

The question says, "Perform RM scheduling for the following task set: T1=(2, 0.5, 4), T2=(3, 1, 10), T3=(5, 1, 10) and T4=(7, 0.45, 15)". Here the standard notation (Period, execution time, relative ...
1
vote
0answers
31 views

Reference book for hydraulic systems design

I'm looking for a good reference book on the topic of fluid dynamics/hydraulics systems engineering. I'd like a reference for simlpe/estimate calculations on things like major losses (pipes), minor ...
1
vote
0answers
24 views

Calculating reliability of a parallel redundant system

I'm trying to calculate the reliability of a system that has proven to be a bit more complicated than I thought. Here is the block diagram for the system: Every single component in this diagram is a ...
1
vote
0answers
45 views

Why a zero too close to the imaginary axis gives bad berformances?

I am studying control systems, and I have found that if I consider I control scheme where I filter the reference , if the zero of the pre-filter is too close to the imaginary axis, we have a ...
0
votes
0answers
23 views

Best way to go about “HiPot” testing setup

What is the best way to set up a dielectric strength test? I am planning on using two threaded copper rods for adjustable movement that will receive the voltage. In between the two rods will be the ...
0
votes
0answers
47 views

effect of coupling in MIMO systems

I have a MIMO system with a 2x2 transfer matrix, for example consider: $\begin{pmatrix} \frac{2}{s+1} & \frac{1}{(s+1)(s+2)}\\ \frac{1}{(s+1)(s+2)}&\frac{2}{s+2} \end{pmatrix}$ I would ...
0
votes
0answers
68 views

Help with Engineering Mathematics, Struggling to determine coefficients using methods detailed in this research paper

I am struggling with a curve fitting calculation below. the part I am stuck with is arguably the simplest part, which is determining the coefficients $\\K_3$ and $\\K_4$. It seems like it should be ...