Questions tagged [pistons]

The tag has no usage guidance.

8 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
6
votes
0answers
126 views

Schematic Reading - Fluid Control Limit Switch Question

Does limit switch LS1 remain pressed on until the piston moves to LS2?
4
votes
2answers
868 views

How Can You Calculate Force to Overcome Friction From an O-Ring Seal?

I essentially have a piston in a tube that is sealed with an O-Ring and actuated with a solenoid. The friction of the O-Ring however, is higher than estimated (guessed as far as I can tell) by the ...
2
votes
0answers
34 views

Fluid for mechanical lubrication and hydraulic connection to plastic/rubber parts

I have a piston made of anodized aluminium and stainless steel with nitrile seals which I need to connect hydraulically to our system which mainly consists of silicone rubber with polycarb and acrylic ...
1
vote
0answers
44 views

Solenoid with 3mm stroke and ~1ms response time possible?

I need to extend and retract a needle as fast as possible with dwell time while retracted, while one option I really like would be to use Scotch Yoke with dwell. However that would mean the stroke and ...
1
vote
0answers
61 views

Are there design reasons why there aren't pneumatic pistons for chairs with a stroke >= 400 mm?

In the interest of saving space, I'd like to have a stool that can double as a table. I'd like the height to be adjustable from 16 inches to 32 inches. But I can't find any pneumatic/spring piston ...
0
votes
0answers
31 views

How do ultra high pressure air compressors work?

I am curious about multistage air compressors used in applications such as scuba tank filling or cryogenic fluid generation. Are there any special considerations applied to the pistons used in the ...
0
votes
1answer
131 views

What is the force needed to exert on the piston for a certain extrusion rate of a syringe tube?

I am trying to design a syringe pump for microfluidic extrusion uses. I have a 5cc syringe tube that I will use as the cartridge. We would be using it to extrude a variety of materials so the ...
0
votes
1answer
240 views

Why aren't modern pistons circular?

I'm trying to make most of an engine from scratch (cylinder, crank case, piston). I've been reading about pistons and I've learned that many modern pistons are cam ground--slightly elliptical in shape ...