Questions tagged [building-physics]

The physics of buildings, specifically thermal conduction, convection, & radiation; heating and cooling; ventilation; transmission and management of water vapour & pollutants

12 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
3
votes
1answer
163 views

Modeling rigid body dynamics: Trouble with equations, encountering nonsense answers

Hi, I am working on modeling a simple rigid body dynamic system through a certain range of motion. Here is the picture of the system. I am trying to solve the system for the variables $x_1'', y_1'', ...
3
votes
0answers
49 views

What is the minimum height of a chimney needed in a camper?

Like a lot of people nowadays, I'm fitting a log fire into the back of a camper van but can't find the minimum height above the roof for the chimney. Ideally, it should be as low as possible for ...
2
votes
0answers
53 views

What would happen if the air conditioning failed in a skyscraper for an extended period?

I'm writing some fiction which involves the AC in a modern glass curtain skyscraper (50-80 floors?) in an American city failing for a period of weeks, maybe even for up to two months. Could anybody ...
2
votes
0answers
22 views

One dimensional U-Factor Calculation - How to determine indoor / outdoor film resistances

Can someone clarify the ASHRAE Fundamental 2017 (SI Units) (See Below) Indoor and Outdoor film resistances. The manual states that it comes from Table 3 and in the description of table 3 it states &...
2
votes
0answers
14 views

Sun light illumination on a lower floor vs high building closely

there is an investor that wants to build very close to our building. In case we agree, the buildings will stand like on the pictures below, 3 meters apart from each other. I tried to draw them in ...
2
votes
0answers
12 views

Increase in target emission rate (TER) when using a air source heat pump (ASHP) in standard assessment procedure (SAP) calculation

I am running a SAP calculation on a proposed building which will be utilising a 8.5 kW ASHP for space and water heating. I am also running a comparative analysis against a mains gas boiler to show the ...
2
votes
0answers
27 views

How to ensure natural ventilation through a shaft?

I have a small shaft, 2.5m wide by 4m deep, sunk into the ground. Due to explosion protection I should ensure "natural ventilation" - this is the termgiven in the relevant ordinance, no air flow ...
1
vote
0answers
25 views

Heat storage mass vs. AIR in an ICF house

If we would want to build a family house (ICF) regarding operational costs, should we leave the insulation on the inside, or should we remove it from the inside? If we would remove it, the walls ...
1
vote
0answers
170 views

equivalent full hours of heating equipment

I would like to know if there is a standard way of calculating the equivalent to a capacity factor but for heating equipment. That is the ratio between the amount of heat delivered during one year ...
0
votes
0answers
17 views

Which will be stronger for securing a cantilever umbrella in a deck

I am securing a cantilever umbrella baseplate to a deck. The decking timber will be reinforced with a pine nog between the deck joists. The options that I have are to use 10mm stainless steel coach ...
0
votes
0answers
36 views

How to estimate the physical parameters of 40% Cu + 60% Mo alloy?

I need to know, or estimate the physical characteristics of the alloy which consists 40% copper and 60% molybdenum. I know only: Density: $9.62 \frac{g}{cm^3}$ Thermal conductivity: $223 \frac{W}{m·K}...
-1
votes
1answer
59 views

calculating energy usage with measuring the temperature

I am an electrical engineer working on a project. My goal of this project is to make an IoT solution where I continuously measure the temperature of room in a building. I want to calculate the amount ...