Questions tagged [brazing]
The brazing tag has no usage guidance.
8
questions
0
votes
1
answer
57
views
How to solder the stainless steel rods
How can we solder two stainless steel rods
material- Stainless steel 304 or SS316
OD-6mm
ID-1.6mm
Depth-4mm
Or there is any other better option to join these two parts?
1
vote
0
answers
29
views
Is it possible to silver solder a reliable grounding connection to a stainless steel ultrasonic cleaner tank?
My ultrasonic cleaner has a stainless steel tank with a threaded grounding stud for fastening a mains earth wire. I tried to tighten nut that fastens the ground terminal to the stud, but the stud ...
- 158
4
votes
4
answers
2k
views
Is it possible to increase the heat output of a gas stove by connecting two gas supply canisters to it at the same time, and is it safe to do so?
Here's a typical outdoor gas stove:
It is fed by a low-pressure gas supply in the form of a camping cartridge or via an LPG cylinder connected to a low-pressure regulator (around 30mbar) like this ...
- 151
-1
votes
1
answer
335
views
What materials can be used for Brazing
I have trouble understanding the Brazing principle. What I know is that there are a couple of filler materials such as copper, silver, aluminim, etc....
What I remember from the past is that the ...
- 151
0
votes
1
answer
395
views
Type of brazing torch / gas that would be appropriate?
I'm a competent DIYer and have done a little small-scale ferrous and non-ferrous brazing in the past. It was in a professional workshop the equipment was provided suitable on request, so I didn't need ...
- 571
0
votes
1
answer
355
views
How is this aluminum heater mounted to the stainless plate?
I'm looking for a way to mount a 1000W electric heater to a stainless base. Electric kettle heaters could fit my requirements, but I'm wondering how the Aluminium heater is mounted to the stainless ...
- 101
0
votes
1
answer
382
views
Aluminium brazing instructions: heat thoroughly to "open the pores" before tinning with rod
I have instructions for using aluminium brazing rod "HTS-2000".
It says:
Clean the area to be worked with a wire brush. Heat the work surface until it is hot enough to melt the rod. Open the pores ...
- 1,274
4
votes
2
answers
769
views
6082 Aluminium softened by brazing. How to harden?
I've started playing around with brazing pieces of extruded aluminium sections to join them together for strong joins as an alternative to bolting them.
The pieces are made of 6082-T6 aluminium alloy....
- 1,274