Questions tagged [bernoulli]
The bernoulli tag has no usage guidance.
25
questions
0
votes
1
answer
17
views
Velocity value in a pipe junction when we're applying the energy equation
I'm trying to understand how to apply the energy equation at a junction of 3 pipes. For example, when we are considering points A and D, should we consider that velocity at point D just before the ...
0
votes
0
answers
5
views
What happens when electrolytic process rotameters are swapped for a much bigger one?
electrolytic process rotameter were swapped for much bigger rotameters. Inlet pipes are the still the same. What effect does the bigger rotameter have in the concentration of catholyte in the cell?
- 1
0
votes
0
answers
58
views
Why is the stagnation pressure equal to the atmospheric pressure in the test section of an open-circuit wind tunnel?
I understand Bernoulli's Principle at different sections of the wind tunnel (static and dynamic pressure), and that it is equal to the atmospheric pressure (hence open-circuit). However, I don't ...
0
votes
3
answers
158
views
Can a fluid have more or less static pressure than atmospheric pressure in atmosphere?
We assume static pressure of a fluid coming out of a pipe or nozzle of gas turbine with high temperature and velocity is equal to atmospheric pressure, which confuses me for some point.
Does it mean ...
- 125
0
votes
1
answer
27
views
Find pressure, given 2 velocities at open end of pipe and inside pipe, at different elevations
There is a tube travelling horizontally, 8m below the ground, with a diameter 15cm. It then turns upwards and at a height of 1.75m above the ground, it shoots water out with a velocity 32 m/s. Find ...
0
votes
1
answer
33
views
How to quantify a misty-ness of a spray?
Picture1 source:
Picture2 source:
Picture3 source:
The above are three spray models. The latter one is fuel injector spray. Consider I have a closed container which I can increase its pressure by any ...
- 219
-1
votes
2
answers
91
views
Incompressible Fluid Flow in horizontal pipe segment which encounters tilted pipe segment - Continuity Equation
Say that we have water flowing horizontally in a pipe of constant diameter. The continuity equation for incompressible fluids, which is a statement of mass conservation, guarantees that the flow rate ...
- 99
0
votes
0
answers
53
views
why the gage pressure of a fluid is zero at locations where the HGL intersects the fluid?
I have searched for answers to this, but so far I have not found any consistent answers. Please, may anyone help me understand this.
- 1
0
votes
1
answer
65
views
Routing the flow from an axial "box" fan
I have a project where I need to generate a certain flow rate to levitate a ping pong ball using the Bernoulli principle. From some rough calculations, I found that it would take about 30 CFM through ...
- 167
0
votes
3
answers
86
views
Increasing air velocity through F1 car diffuser
I am looking into F1 car aerodynamics for a course that I am taking.
I understand that because of Bernoulli's law, when the velocity increases, the pressure decreases, which is good for F1 cars if we ...
0
votes
1
answer
48
views
Pressure variation through reduction (Bernoulli) and pipe wall design
Let's say I have a pipe followed by a reduction and then another smaller diameter pipe continues. Using conservation of mass, the flow through the smaller diameter pipe will have higher velocity. If I ...
2
votes
1
answer
129
views
Isn't the Bernoulli equation just a special case of the Steady-flow equation?
This question is about the following two energy balance equations (assuming no energy input/output):
Bernoulli: $\frac{p}{\rho} +\frac {v^2}{2} + zg = const.$
Steady-flow: $u +\frac {p}{\rho} +\frac{...
0
votes
1
answer
73
views
Water flow rate generated by a pressure steam tank
I have a 5 $m^3$ capacity tank that generates steam with a heat exchanger.
This tank is under 15 bar pressure. The water in the bottom part of the tank does not completely vaporize because there is ...
- 23
1
vote
0
answers
63
views
Efflux velocity for system with air and liquid
I want to calculate the efflux velocity for this open vessel with area $A_1$ with a small outlet with area $A_2$ as a function of time. The atmospheric pressure is $p_0$.
The vessel has height $h = h_{...
0
votes
2
answers
535
views
Is Bernoulli’s equation applicable for systems with pumps?
Please have patience with me as I have not looked at this sort of theory in many years (I am also very new to StackExchange).
A question asks the following:
A sloping swimming pool two-thirds full of ...
1
vote
2
answers
54
views
Can I dismiss wind loads for this solar panel configuration?
I asked this question before in the Physics Stack Exchange, but it was closed because it was considered being about engineering. That is why I am asking it here.
I am planning to install some solar ...
2
votes
0
answers
61
views
Help calculating discharge rate from a reservoir as the water level drops?
I could do with some help calculating the discharge rate from a reservoir and factoring in how that flow will decrease as the head of water decreases.
The information I have is:
Maximum height of ...
- 21
1
vote
1
answer
218
views
Venturi Duct flow
When water flows through the converging side of a Venturi, why is it that the total head (experimental and calculated) is not constant? Could it be due to losses?
Also, why was it that a lot more ...
1
vote
0
answers
31
views
Bernoulli head losses
For a Venturi, I calculated total head theoretically and experimentally. I noticed that the last point along the Venturi has not got the same as the start point total head? Shouldn’t it be the same ...
- 11
0
votes
1
answer
114
views
Calculating Pipe Leak Flow Rate
Just curious and working on some hypothetical problems on my own...I'm currently studying for my PE license. Also, trying my best here with the Latex stuff.
Let's say there's a crude oil pipeline and ...
- 113
2
votes
2
answers
68
views
If a gas is pushed through a widening section of a pipe with a piston, will the pressure increase?
Imagine I have a section of pipe that increases in cross-section at some point. If the gas in the pipe before this section is being displaced with a piston, will the gas increase its pressure and ...
- 378
1
vote
2
answers
175
views
Bernoulli equation on moving cart
Let’s say I have moving cart with velocity U .
And water from pipe flows at velocity V with respect to ground
The question asks to use Bernoulli equation , pressure is atmospheric in the top
If I use ...
- 131
0
votes
1
answer
93
views
Quantifying the reaction force on fixed tubing connected to a peristaltic pump
I am not sure how I should consider the forces due to hydrostatic pressure when calculating the reaction force due to a fluid being pumped through fixed tubing with a peristaltic pump that I am using ...
- 162
-1
votes
1
answer
89
views
Fluid Mechanics Question
I am preparing for GATE(Chemical). I need the answer of this question part 2 (question 54) as I am not able to find the mistake in my logic.
I have applied the logic here as:
Initial energy stored in ...
2
votes
1
answer
182
views
Limits of Euler-Bernoulli Beam Theory for Wide Plate in Flexure?
I'm looking for established limits or rules of thumb for the validity/accuracy of Euler-Bernoulli beam equations for particularly wide "beams". For example, a simply supported rectangular ...
- 725