Questions tagged [abs]

The tag has no usage guidance.

Filter by
Sorted by
Tagged with
1 vote
1 answer
35 views

Algorithm to detect flat tyre by comparing wheels speeds

So ABS systems are capable of detecting a flat tyre, because it will roll a bit faster (because of smaller diameter). What could be speed difference, needed to detect such fault? Do ABS systems only ...
Ri Di's user avatar
  • 121
1 vote
1 answer
36 views

Injection molding: What is best for a dual cavity single mold?

I would like to understand what's the best optimization in terms of design for a single mold, dual cavity of a two-part box (top and bottom parts) which should be hold together with 4 screws without ...
gregoiregentil's user avatar
2 votes
1 answer
929 views

How well does epoxy bond to PETG / ABS vs Wood?

I know that PLA does not bond at all, just peel right off But i'm wondering about PETG or ABS Will they bond just as well as wood?
Simon's user avatar
  • 105
0 votes
2 answers
62 views

Which glue is good for transparent ABS plastic and easy removal?

Hello all I need to glue some ABS plastic parts together some of them are transparent. I used AA glue before but it will make my transparent parts foggy and after sticking them together its nearly ...
tempo3010's user avatar
0 votes
0 answers
91 views

Long term deflection

I've been working with a team of 'designers' that are highly concerned over a potential failure mode of ABS plastic. Their theory is that under a static load well under the yield point of the material ...
Diesel's user avatar
  • 632
3 votes
0 answers
26 views

Forces on a wheel during braking (Quarter Vehicle Model)

I have created a simple xcos simulation for quarter wheel using the equations given at the bottom of the image. I understand the total torque on the wheel will be the braking torque and the friction ...
amekha's user avatar
  • 31
0 votes
1 answer
32 views

Temperature vs Material Properties - ABS

I'm working on a design that uses fairly large plastic components (ABS, ~400mm longest dimensions). I'm looking at adding a steel component that encapsulates this plastic part. And, the steel part ...
Diesel's user avatar
  • 632
0 votes
1 answer
60 views

Material Properties of ABS

I've been working on a design that requires a plastic snap feature. I've assumed up to this point that the material will be injection molded ABS, with material properties I pulled off of matweb. ...
Diesel's user avatar
  • 632