I'm going to simulate an automotive radiator . The method called $\varepsilon$- NTU , suggests following steps to calculate the heat rejection,$Q$, of a heat exchanger:
1-calculate $U$(overall heat transfer coefficient)
2- calculate $NTU$
3- calculate $\varepsilon$ and finally calculate $Q(W)$.
My question is about calculation of $U$ in automotive radiators. We can neglect fouling and wall resistances and write: $$ \frac{1}{UA} = \frac{1}{\eta_aA_ah_a}+\frac{1}{A_wh_w} $$ $U$: Overall heat transfer coefficient.
$A$ : Air side or waterside area.
$A_a$ : Air side heat transfer area
$A_w$: Waterside heat transfer Area
$h$ : heat transfer coefficient
$\eta_a$ air side surface efficiency.
I want to use Shanoun & Webb formula to calculate the first term of the above equation(Air thermal resistance). They propose following equation for automotive radiators: $$ (\eta Ah)_a=(\eta_f Ah)_{l} +(\eta_f Ah)_{S1}+(\eta_f Ah)_{S2}+h_eA_e$$ You can find regions named louvered(l),S1,S2 and e in following image: This is image of a fin between 2 flat tubes.
Question: Shanoun and Webb just enter areas relating to one fin in their equation. So when we want to calculate $UA$, we account total surface of water$A_w$ but just a small surface of air side$A_a$. It makes the answer wrong. How can we use this formula to calculate $UA$ ?


I should multiply the No. of fins to the right-hand-side statement. So we have: $$(\eta hA)_a=No.of fins \times( (\eta_fhA)_l+(\eta_fhA)_{S1}+(\eta_fhA)_{S2}+h_eA_e)$$

| improve this answer | |
  • $\begingroup$ Is this an answer or is it supposed to be added to the question? $\endgroup$ – hazzey Feb 1 '16 at 1:59
  • $\begingroup$ It is the answer. $\endgroup$ – Alish Feb 1 '16 at 11:08

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.