I got a question thats been bugging me for a while:
Say that you're given a straight square beam (say one meter long), and you attach three strain gauges on each face. One at 0 degrees, one at 45 degrees and one at 90 degrees. All of these gauges are flat against the beam, so they measure in plane.
My question is: given these strains, could you reconstruct the geometry?
- The material is linear
- The deformations are small
I've been trying it for a while, and I can always resolve for the compression and curvature, but the rotation seems to elude me. For simple cases (like pure bending) it works fine, the sensor at 45 degrees are linearly correlated to the bending. However, when shear is present, these seems not to be the case anymore. As of yet, I can't find a way to correct for this. Anyone got an idea? This problem has probably already been solved by someone else, but I can't seem to find a good reference to this (for the 3D case).
Any help is greatly appreciated!
Edit: images included
Front view of a small section of beam. The red images indicate strain gauges. As can be seen, only strains in plane can be measured.
Isometric view of a small section of beam, showing two strain gauges as well as the axis. The torsion mentioned would work on the y axis.