2
$\begingroup$

A hardened steel contour with a sharp edge presses against plastic foil which lies on top of a hardened steel anvil plate. What would be the force required to punch through the foil?

I am familiar with the general punching/blanking formula, however, as far as I know this only applies to punching into a die i.e. the countour goes fully through the sheet. A picture is added to further clearify the question.

General blanking formula: \begin{equation} F = K*l*t*\tau \end{equation}

where $K$ is a material/safety factor, $l$ the circomference of the contour, $t$ the sheet thickness and $\tau$ the shear stress.

enter image description here

Improve this question
$\endgroup$
2
  • $\begingroup$ So, you say the hardened steel tool has to go through the plastic and you state the formula is for a tool to go through material. Then why do you think it is not relevant? $\endgroup$
    – Solar Mike
    Commented Sep 7, 2022 at 13:42
  • $\begingroup$ The formula is for full puncturing. In this case the contour cannot fully pass through the foil. It can only press against a bottom anvil with the foil in between. I can imagine this might not match the given formula but I'm more than happy to be told otherwise. $\endgroup$
    – jessegerritsen
    Commented Sep 7, 2022 at 14:17

1 Answer 1

Reset to default
0
$\begingroup$

Common plastic used in grocery shopping has an average shear strength of 200-500 psi. Or check the datasheet!

One could multiply this by the length of the cut, or perimeter of the circle.

A punching tool with a sharp edge and slanted strike can cut with much less force, but one has to be careful to halt the tool before it actually hard lands on the anvil!

Improve this answer
$\endgroup$

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.