0
$\begingroup$

I'm trying to retrofit an electric motor (such as this) to a pull cart as depicted below. I got most things figured out except for how to slow down the motor to a pedestrian speed.

Could I slow it down by reducing the amperes? Or must I use a lower gear ratio?

enter image description here

$\endgroup$
4
  • $\begingroup$ So did you check out the pedal assist as per your post and the comments here: engineering.stackexchange.com/q/51117/10902 $\endgroup$
    – Solar Mike
    Jun 1 at 13:55
  • $\begingroup$ And the answer here: engineering.stackexchange.com/a/51115/10902 $\endgroup$
    – Solar Mike
    Jun 1 at 13:56
  • $\begingroup$ @SolarMike Thank you for reminding me. I missed it but I just replied them. $\endgroup$
    – ratib90486
    Jun 1 at 14:40
  • $\begingroup$ If you're trying to avoid a gearbox, which is understandable since gearboxes are expensive, you just use a chain drive or a belt. You need to attach a motor to each wheel anyways and it's unlikely that the motor can support the weight of the cart on its own shaft. $\endgroup$
    – DKNguyen
    Jun 1 at 14:59

1 Answer 1

0
$\begingroup$

The specific motor that you linked is a BLDC motor and requires a controller. The multitude of wires coming out is a tell.

This controller will be what will regulate the speed. By turning on and off certain coils in a rythm.

To set the speed to your liking you will need to program the controller to your needs.

$\endgroup$
3
  • $\begingroup$ When you said program the controller, how difficult will that be? Is the controller meant to be reprogrammed and comes with a manual for this? I mean are most are? $\endgroup$
    – ratib90486
    Jun 1 at 14:34
  • 1
    $\begingroup$ depends on the controller you get. Some are very locked off, and some let you rewrite the entire code. $\endgroup$ Jun 1 at 15:49
  • $\begingroup$ @ratib90486 You will need to buy a brushless motor controller (also known as ESC - electronic speed controller) to use this motor. A brushless motor won't spin if you just plug it into a power source. It needs the electronics. $\endgroup$
    – user253751
    Jun 8 at 16:27

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.