1
$\begingroup$

I need to construct the auxiliary views with the given front and right side orthographic views. The view is in third angle projection.

enter image description here

I observed that there is an oblique surface so that perhaps I need to construct here the secondary auxiliary view. However, I am confused in constructing those auxiliary views. I cannot make the oblique surface appear as an edge in the primary auxiliary view. I am stuck. Here, I already constructed the isometric view as my guide. enter image description here

This is my outline for the construction of primary auxiliary view and I don't know what to do with the oblique surface and how to connect the points. My attempt is to use the fold-line method.

enter image description here

$\endgroup$
2
  • $\begingroup$ Have you given us the whole question? Are there any clues missing from your post? $\endgroup$
    – Transistor
    Jul 19 at 17:14
  • $\begingroup$ @Transistor thanks for the correction of my isometric view btw. I have a concern about constructing its primary and secondary auxiliary views. There is an oblique surface that I think I need to appear it as an edge in the primary auxiliary view. When I tried doing it, I cannot appear it as a single line or as an edge. That is where I am stuck to. $\endgroup$
    – Sigz
    Jul 20 at 2:09
2
$\begingroup$

It's a tricky one.

enter image description here

Figure 1. Your isometric is missing this line.

enter image description here

Figure 2. A clue. The six-cornered shape is flat so it must be a plane going through these three points. Can you draw it?

enter image description here

Figure 3. The correct isometric view.

enter image description here

Figure 4. Slide 25 by Shelly Wilke on SlideShare. This and slide 9 may be instructive.

$\endgroup$
1
$\begingroup$

You did pretty well, but @Transistor is correct that the horizontal line needs to be extended. Maybe it looks like this. However, I don't think the inclined plane is correct as there will be another line (shown in red) to connect the corners.

enter image description here

$\endgroup$
4
  • 1
    $\begingroup$ I had added in the >! spoiler markup to your picture in case the OP still wants to work it out. It disappeared in your edit - I don't know if you had noticed it. There won't be a red line. See my answer which I generated with a plane split with OnShape. $\endgroup$
    – Transistor
    Jul 19 at 18:52
  • $\begingroup$ @transistor I guessed it was your intent, but I know there is something wrong with my drawing, so I purposely leave it for further discussion. Let's wait and see. $\endgroup$
    – r13
    Jul 19 at 19:00
  • $\begingroup$ Thanks for the correction, but I have a concern with the six-sided oblique surface. I am struggling on how to make a primary and secondary auxiliary view because of it. Give me ideas on how to make it. $\endgroup$
    – Sigz
    Jul 20 at 9:10
  • $\begingroup$ I suggest creating the top view, then take projection on the inclined plane. Here are two articles that might help. skillscommons.org/bitstream/handle/taaccct/9338/…, ceet.niu.edu/faculty/kim/mee270/…. $\endgroup$
    – r13
    Jul 20 at 13:16

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.