0
$\begingroup$

enter image description here

It's for an NX part. I can't figure out the depths and such. I just know the placement of the 4 holes and that the diameters are 10 mm each.

$\endgroup$
5
  • 1
    $\begingroup$ 4 - number 10 bolts "thru" 9.5 mm bdiameter oreholes. $\endgroup$ – r13 May 7 at 18:16
  • $\begingroup$ Standard counterbore depth for a #10 thru hole is .19 in (4.8 mm). Thru hole diameter for a #10 screw is .201 in (5.1 mm) $\endgroup$ – jko May 7 at 18:36
  • 1
    $\begingroup$ Is #10 not a drill size, rather than a bolt/screw size? (I'm not experienced with inch stuff) $\endgroup$ – Jonathan R Swift May 7 at 18:52
  • $\begingroup$ One thing is for certain, there is not a 10mm diameter in this image $\endgroup$ – Jonathan R Swift May 7 at 18:56
  • $\begingroup$ #10 drill = 0.1935 inch, quite similar to #10-24 UNC thread OD. This is a total coincidence however. drill # decreases with diameter, UNC thread size # increases with diameter $\endgroup$ – Pete W May 7 at 18:56
2
$\begingroup$

To expand on comments:

This drawing is a little bit sloppy. As it's a clearance hole, it should just indicate thru diameter and both diameter and depth of cbore. Takes almost no effort in any remotely modern CAD.

When I did some mechanical design, I wouldn't be allowed to do this. Might receive a call from the prototype shop asking me to clarify my intention, might get shot down by the doc control guy in release process.

Most likely interpretation is standard clearance dimensions for #10 screw, as @jko says, but there is ambiguity vs #10 drill per @Jonathan R Swift. By complete coincidence, sizes are similar.

If you can call/email whoever originated the drawing, that might be the way to go.

$\endgroup$
0
$\begingroup$

Rather than a counterbore I suspect that it is a countersink, in which case, I would include the angle. Generally, English hardware uses 82-deg heads whereas Metric uses 90-deg heads. The #10 may just be indicting the English drill size for the through hole, 0.1935-inch diameter (mixing English drill hardware and Metric measurements). If it is a counterbore, then yes, the counterbore depth is missing.

$\endgroup$

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.