Does anyone have insights into configuring UART port on Renesas RX130 microcontroller for a bit rate of 115200? I have successfully configured for a 9600, 19200, and 38400. I can read from the MCU and write to the MCU via terminal programs such as tera term. I am using the code generator available through e2Studio IDE.. I am using Serial Communication Interface SCI1, from which I have configured RXD1 / P30 (Pin 18) and TXD1 / P26 (Pin 20). Note P30 is port 3 bit 0 and P26 is port 2 bit 6.
Has anyone run into similar issues? Thanks for your help!
Note: I am open to exploring Firmware Integration Tool (FIT) to configure UART ports