1
$\begingroup$

In MMPDS for AA7075-73511 (extruded rod) the Table 3.7.10.0(g3) show both ST and LT values for transverse directions. For a rod with circular cross section there is really no Short and Long transverse directions. Which one should i choose? Do not want to be uneccassary conservative and choose ST-values if it is not applicable. In my case I'm looking at the higher end off the table with diameters around 4in.

$\endgroup$

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Browse other questions tagged or ask your own question.