Skip to main content
Engineering

Return to Answer

Formating the list
Source Link
edit approved Dec 1, 2017 at 21:20
Adrian Maire
edit approved Dec 1, 2017 at 21:20
Adrian Maire
  • 348
  • 1
  • 13

1 - This is an indication of surface finish. 2 - This is an indication of a datum 3 - This is an indication of concentricity 4 - This is an indication of runout 5 - This is an indication of perpendicularness

  1. This is an indication of surface finish.
  2. This is an indication of a datum
  3. This is an indication of concentricity
  4. This is an indication of runout
  5. This is an indication of perpendicularness

Almost all of these relate to GD&T, which I would recommend you read up on. The fact that you don't know these shows a general lack of knowledge. I would recommend skimming something like ASME y-14.5, or taking a class on drafting.

1 - This is an indication of surface finish. 2 - This is an indication of a datum 3 - This is an indication of concentricity 4 - This is an indication of runout 5 - This is an indication of perpendicularness

Almost all of these relate to GD&T, which I would recommend you read up on. The fact that you don't know these shows a general lack of knowledge. I would recommend skimming something like ASME y-14.5, or taking a class on drafting.

  1. This is an indication of surface finish.
  2. This is an indication of a datum
  3. This is an indication of concentricity
  4. This is an indication of runout
  5. This is an indication of perpendicularness

Almost all of these relate to GD&T, which I would recommend you read up on. The fact that you don't know these shows a general lack of knowledge. I would recommend skimming something like ASME y-14.5, or taking a class on drafting.

Source Link
user1814893
user1814893
  • 131
  • 3

1 - This is an indication of surface finish. 2 - This is an indication of a datum 3 - This is an indication of concentricity 4 - This is an indication of runout 5 - This is an indication of perpendicularness

Almost all of these relate to GD&T, which I would recommend you read up on. The fact that you don't know these shows a general lack of knowledge. I would recommend skimming something like ASME y-14.5, or taking a class on drafting.